ERROR CODE EXPLAINED
Electrolux Front Load Washer
Electrolux Front Load Washer E35 Error Code
What it means
The washer pressure sensor is indicating a water-overfill condition.
Try this first
- If the washer was recently installed or moved, have the installer verify the installation.
- Press Cancel to clear E35, then press Start to resume the cycle.
- For a hard reset, disconnect the AC power cord, reconnect it, wait a few seconds for the cycle to end or beep, and restart the cycle.
- If the condition remains, arrange service.
Can I keep using it?Follow the manufacturer checks that match the condition shown by the appliance; model-specific details can vary.
Repair usually required?If the manufacturer directs the issue to service or the listed checks do not clear it, arrange professional appliance service.
If the error keeps returning
Use the linked official manufacturer support article for the exact source guidance and model-specific details.
Official source
Troubleshooting information verified against manufacturer support documentation.
View manufacturer support page →Safety note:ApplianceSignal provides general troubleshooting information. Always follow the appliance manufacturer's safety instructions and disconnect power when required.