ERROR CODE EXPLAINED
Jennair Dishwasher
Jennair Dishwasher F9E1 Error Code
What it means
JennAir identifies dishwasher F9E1 as a long-drain condition.
Try this first
- Remove the dishwasher filter and clean it thoroughly under running water.
- Inspect the drain hose from the dishwasher to the sink for kinks, pinching, or clogs.
- If connected to a sink disposer, make sure the disposer is clear and that its knockout plug was removed during installation.
- If an air gap is installed, inspect and clear it according to its manufacturer's instructions.
- Check the drain and disposer for food or other obstructions and run the disposer to clear it.
- Make sure the drain hose is routed correctly and is not kinked or clogged.
- Disconnect dishwasher power for 30 seconds and then restore power.
- If F9E1 returns after the drain checks and power reset, schedule service.
Can I keep using it?⚠ JennAir identifies dishwasher F9E1 as a long-drain condition.
Repair usually required?⚠ Follow only the manufacturer-backed checks listed on this page before replacing parts.
If the error keeps returning
Use the linked official manufacturer support article for additional model-specific guidance.
Official source
Troubleshooting information verified against manufacturer support documentation.
View manufacturer support page →Safety note:ApplianceSignal provides general troubleshooting information. Always follow the appliance manufacturer's safety instructions and disconnect power when required.