ERROR CODE EXPLAINED

KitchenAid Wall Oven

KitchenAid Wall Oven Feature Not Available Error Code

← Back to Error Search

What it means

Feature Not Available / Fault Detected can appear when the oven detects a fault while you are programming a cook cycle.

Try this first

  1. Follow the display prompt: press ENTER to try again, or disable power if the display says "DISABLE POWER TO CLEAR."
  2. If the message remains, turn off the oven circuit breaker(s) for 1 minute.
  3. Restore power.
  4. Start a bake cycle.
  5. Monitor the oven for 1 minute and verify operation.
Can I keep using it?⚠ Programming fault detected
Repair usually required?⚠ Service may be required if the message returns

If the error keeps returning

If the message returns after following the display prompt and completing the power reset, KitchenAid recommends service.

Official source

Troubleshooting information verified against manufacturer support documentation.

View manufacturer support page →
Safety note:ApplianceSignal provides general troubleshooting information. Always follow the appliance manufacturer's safety instructions and disconnect power when required.

More KitchenAid Wall Oven Codes

FC E1FC E1 means the wall oven could not connect to the wireless router. KitchenAid lists a connection timeout, weak signal, failed router, the appliance Wi-Fi module, or associated wiring as possible causes.FC E2FC E2 means the wall oven could not connect to the wireless router. KitchenAid lists a connection timeout, weak signal, failed router, the appliance Wi-Fi module, or associated wiring as possible causes.FC E3FC E3 means the wall oven could not connect to the wireless router. KitchenAid lists a connection timeout, weak signal, failed router, the appliance Wi-Fi module, or associated wiring as possible causes.FC E4FC E4 can indicate a problem with the Wi-Fi Antenna, or the associated wiring.
View all KitchenAid Wall Oven codes →
← Look up another error code

KitchenAid Wall Oven Feature Not Available: Quick Answer

What it means: Feature Not Available / Fault Detected can appear when the oven detects a fault while you are programming a cook cycle.

First thing to check

Follow the display prompt: press ENTER to try again, or disable power if the display says "DISABLE POWER TO CLEAR."

Can I keep using it?

Programming fault detected

Repair outlook

Service may be required if the message returns

If the code remains

If the message returns after following the display prompt and completing the power reset, KitchenAid recommends service.

Model note: Error-code meanings and procedures can vary by model and model year. Confirm the code against the documentation for your exact appliance before replacing parts.

Manufacturer reference: producthelp.kitchenaid.com

Related KitchenAid Wall Oven Error Codes

Check these other KitchenAid Wall Oven codes if the display changes or you are comparing similar faults.

FC E9LOC / LockedFC E8Power LossFC E7Press Cancel to ResetFC E6Probe / Insert ProbeFC E5PUSH / PSHFC E4SABFC E3FC E2FC E1F9 E0
All KitchenAid Wall Oven Error CodesAll KitchenAid Appliance Error Codes

More KitchenAid Appliance Guides

Dishwasher31 codesMicrowave48 codesRange / Wall Oven11 codesRefrigerator15 codes
About these guides:SourcesHow content is organizedCorrectionsSafety