ERROR CODE EXPLAINED
Maytag Front Load Washer
Maytag Front Load Washer F8 E3 Error Code
What it means
The washer detected an overflow condition caused by too much water or excessive foam.
Try this first
- Stop adding detergent.
- Use only High Efficiency detergent.
- Reduce the amount of detergent if excessive suds are present.
- Allow the current cycle to finish if the washer is removing suds.
- Run the Clean Washer cycle after the condition has cleared.
- Check for continued overfilling before using the washer normally.
Can I keep using it?🔴 Stop and investigate if water level is excessive
Repair usually required?⚠ Sometimes
If the error keeps returning
If F8 E3 returns without excessive detergent or suds, the water-level or fill system may require diagnosis.
Official source
Troubleshooting information verified against manufacturer support documentation.
View manufacturer support page →Safety note:ApplianceSignal provides general troubleshooting information. Always follow the appliance manufacturer's safety instructions and disconnect power when required.