APPLIANCE TROUBLESHOOTING
Speed Queen Top Load Washer Error Codes
Find plain-language explanations for Speed QueenTop Load Washer error codes, common causes, and troubleshooting steps you can try before requesting repair service.
12 error codes currently available
Blinking Left Decimal Point
The washer did not reach the intended maximum speed during final spin.
View error details →
Er, dr
Water remains in the washer at the end of the cycle.
View error details →
Er, FL
The washer did not reach the required fill level within 30 minutes.
View error details →
Er, LL / Er, Ll
The washer detected a lid-lock state problem. Depending on the displayed letter case, the lid may have unlocked during a cycle or may have failed to lock.
View error details →
Er, Lo
The washer detected that the lid opened during a running cycle.
View error details →
Er, LU
The washer lid will not unlock.
View error details →
Er, nF
The washer did not reach the proper water level during filling.
View error details →
Er, OF
The washer filled to the overflow level.
View error details →
Er, PS
The washer control detected trouble sensing the water fill level.
View error details →
Er, SL
The washer detected an oversudsing condition.
View error details →
PF
A power failure occurred while Delay Start was active.
View error details →
Sr
The washer detected excessive suds and is running a special routine to remove them.
View error details →
Manufacturer information
ApplianceSignal troubleshooting information is based on manufacturer support documentation and rewritten in plain language.