ERROR CODE EXPLAINED
Whirlpool Dishwasher
Whirlpool Dishwasher F8E4 Error Code
What it means
The dishwasher detected water in the drip tray.
Try this first
- Check the water-supply connections for leaks and verify the fill-hose connection is sealed correctly.
- Make sure the float-switch connector is fully connected.
- If water is in the drip tray, remove and empty the tray carefully without pulling on the float-switch wire.
- Press Cancel once to silence the alarm and press Cancel again to clear the code.
- For a professionally installed unit that starts the drain sequence, turn off the water supply, keep the door closed, and do not turn off power while the drain sequence runs.
- If the condition returns or a leak cannot be corrected, arrange service.
Can I keep using it?Follow the manufacturer checks that match the condition shown by the appliance; model-specific details can vary.
Repair usually required?If the manufacturer directs the issue to service or the listed checks do not clear it, arrange professional appliance service.
If the error keeps returning
Use the linked official manufacturer support article for the exact source guidance and model-specific details.
Official source
Troubleshooting information verified against manufacturer support documentation.
View manufacturer support page →Safety note:ApplianceSignal provides general troubleshooting information. Always follow the appliance manufacturer's safety instructions and disconnect power when required.