ERROR CODE EXPLAINED
Whirlpool Dishwasher
Whirlpool Dishwasher F9E1 Error Code
What it means
The dishwasher detected a long-drain or not-draining condition.
Try this first
- Remove the dishwasher filter and clean it thoroughly under running water.
- Check the drain hose for kinks, pinching, or clogs between the dishwasher and sink.
- If connected to a disposer, make sure the disposer is clear and that the knockout plug was removed on a new installation.
- If an air gap is installed, clear it according to its manufacturer instructions.
- Disconnect power to the dishwasher for 30 seconds, then restore power.
- Check for excessive suds and use only detergent made for automatic dishwashers.
- If the problem continues, arrange service.
Can I keep using it?Follow the manufacturer checks that match the condition shown by the appliance; model-specific details can vary.
Repair usually required?If the manufacturer directs the issue to service or the listed checks do not clear it, arrange professional appliance service.
If the error keeps returning
Use the linked official manufacturer support article for the exact source guidance and model-specific details.
Official source
Troubleshooting information verified against manufacturer support documentation.
View manufacturer support page →Safety note:ApplianceSignal provides general troubleshooting information. Always follow the appliance manufacturer's safety instructions and disconnect power when required.