ERROR CODE EXPLAINED
Whirlpool Top Load Washer
Whirlpool Top Load Washer F8 E6 Error Code
What it means
Whirlpool indicates F8 E6 can have two meanings depending on the washer model: the lid is open during the soak cycle, or the washer did not detect hot water.
Try this first
- If the lid is open during the soak cycle, close the lid to resume the cycle.
- If the code is related to no hot water, check whether the hot and cold inlet hoses are reversed.
- If the hoses are reversed, connect the cold water hose to the cold inlet and the hot water hose to the hot inlet.
- Run another cycle after correcting reversed hose connections.
- Make sure both the hot and cold water valves are fully open.
- Make sure both hot and cold inlet hoses are connected to the washer.
- Disconnect the washer from its power source for 5 minutes.
- If the washer is plugged into an outlet, leave it unplugged for the full 5 minutes.
- Reconnect the washer to power.
- Check whether the code returns.
Can I keep using it?⚠ F8 E6 has two possible meanings depending on the model
Repair usually required?⚠ Check the lid condition and hot-water supply before further diagnosis
If the error keeps returning
If F8 E6 returns after checking the lid, hose connections, water supply, and completing the 5-minute reset, use the linked Whirlpool Product Help article.
Official source
Troubleshooting information verified against manufacturer support documentation.
View manufacturer support page →Safety note:ApplianceSignal provides general troubleshooting information. Always follow the appliance manufacturer's safety instructions and disconnect power when required.