ERROR CODE EXPLAINED

Cove Dishwasher

Cove Dishwasher 70 01 97 Error Code

What it means

Cove identifies error 700197 as PE1, a pressure-sensor overfill fault detected during an active wash cycle.

Try this first

  1. Verify that an overturned bowl or additional liquid was not added to the load.
  2. Remove and clean the dishwasher filters.
  3. Cancel and restart the wash cycle.
  4. If the issue remains after the listed checks, contact Factory Certified Service to schedule a repair appointment.
Can I keep using it?⚠ Error 700197 indicates an overfill condition detected during an active wash cycle
Repair usually required?✅ Check for added liquid or an overturned bowl and clean the filters before escalating to service

If the error keeps returning

Contact Factory Certified Service if error 700197 remains after restarting the cycle.

Official source

Troubleshooting information verified against manufacturer support documentation.

View manufacturer support page →
Safety note:ApplianceSignal provides general troubleshooting information. Always follow the appliance manufacturer's safety instructions and disconnect power when required.

Cove Dishwasher 70 01 97: Quick Answer

What it means: Cove identifies error 700197 as PE1, a pressure-sensor overfill fault detected during an active wash cycle.

First thing to check

Verify that an overturned bowl or additional liquid was not added to the load.

Can I keep using it?

Error 700197 indicates an overfill condition detected during an active wash cycle

Repair outlook

Check for added liquid or an overturned bowl and clean the filters before escalating to service

If the code remains

Contact Factory Certified Service if error 700197 remains after restarting the cycle.

Model note: Error-code meanings and procedures can vary by model and model year. Confirm the code against the documentation for your exact appliance before replacing parts.

Manufacturer reference: subzero-wolf.com

Related Cove Dishwasher Error Codes

Check these other Cove Dishwasher codes if the display changes or you are comparing similar faults.