APPLIANCE TROUBLESHOOTING
Cove Dishwasher Error Codes
Find plain-language explanations for CoveDishwasher error codes, common causes, and troubleshooting steps you can try before requesting repair service.
15 error codes currently available
05 01 03
Cove identifies dishwasher error 050103 on the DW2451 as PCB Hardware Issue #1.
View error details →
05 01 18
Cove identifies error 050118 as a wash pump drive system over-voltage Vbus error.
View error details →
05 01 24
Cove identifies error 050124 as a wash pump drive system power-fail dangerous error.
View error details →
05 01 38
Cove identifies error 050138 as a wash pump drive system motor communication error.
View error details →
05 01 80
Cove identifies error 050180 as a wash pump drive system SV transmission error.
View error details →
05 01 87
Cove identifies error 050187 as a dishwasher water-flow problem.
View error details →
20 01 93
Cove identifies error 200193 as HTR1 being on too long because the water did not heat to the required cycle temperature within the expected time.
View error details →
30 01 14
Cove identifies error 300114 as the Clean Filter reminder indicating that the dishwasher sump filtration system needs to be cleaned.
View error details →
57 01 14
Cove identifies error 570114 as FLT2, indicating low salt in the dishwasher water-regeneration tank.
View error details →
57 01 54
Cove identifies error 570154 as LE1, indicating low rinse aid.
View error details →
70 01 97
Cove identifies error 700197 as PE1, a pressure-sensor overfill fault detected during an active wash cycle.
View error details →
80 01 40
Cove identifies error 800140 as MOT4: the drain pump has run too long while draining, or the secondary pressure check could not resolve the drain condition.
View error details →
90 01 31
Cove identifies dishwasher error 900131 on the DW2451 as Control System - Software Incompatibility Issue #4.
View error details →
98 01 99
Cove identifies error 980199 as a power interruption that occurred while the dishwasher was running a wash cycle.
View error details →
Call Service
Cove says a Call Service message can indicate a fault-level error or a software or hardware loading error.
View error details →
Manufacturer information
ApplianceSignal troubleshooting information is based on manufacturer support documentation and rewritten in plain language.