APPLIANCE TROUBLESHOOTING
Ge Dishwasher Error Codes
Find plain-language explanations for GeDishwasher error codes, common causes, and troubleshooting steps you can try before requesting repair service.
17 error codes currently available
1H / Number + H
The dishwasher is in Delay Start mode.
View error details →
999
GE says 999 can indicate a Floor Protect leak condition on equipped models; on other models it may be cleared by resetting the control.
View error details →
C1
The dishwasher drain pump has been running for more than 2 minutes.
View error details →
C2
The total dishwasher pump-out cycle has exceeded 7 minutes.
View error details →
C3
The dishwasher is not draining.
View error details →
C4
The dishwasher may have filled twice after a power failure, or the float switch, drain, or sump may be obstructed.
View error details →
C5
The dishwasher pump-out time was shorter than expected.
View error details →
C6
The dishwasher detected that the incoming water temperature is too low.
View error details →
C7
The dishwasher detected a problem with the water-temperature sensor circuit.
View error details →
C8
The detergent cup is blocked and cannot open completely.
View error details →
Cup Open
GE says CUP OPEN means the detergent cup is not closed.
View error details →
F56
GE says F56 indicates a failed-drain condition.
View error details →
FTD
GE says FTD indicates a failed-drain condition.
View error details →
H2O
GE says H2O indicates a low-water or fill condition.
View error details →
LEAK DETECTED
GE says LEAK DETECTED means the dishwasher detected a possible leak and canceled the cycle.
View error details →
PF
Power to the dishwasher was interrupted.
View error details →
PrS
GE says PrS indicates an invalid pressure-sensor signal, commonly involving the pressure sensor or its harness.
View error details →
Manufacturer information
ApplianceSignal troubleshooting information is based on manufacturer support documentation and rewritten in plain language.