ERROR CODE EXPLAINED
Miele Dishwasher
Miele Dishwasher F13 Error Code
What it means
The dishwasher water inlet is blocked or restricted.
Try this first
- Open the water faucet fully.
- If the inlet filter is dirty, switch the dishwasher off, unplug it, close the faucet, remove the water-intake-valve filter and seal, rinse the filter, then reinstall the filter and seal correctly before reconnecting.
- Open the faucet slowly after reassembly and tighten the connection if it leaks.
- Remove any kinks or loops from the water inlet hose; replace a damaged hose rather than continuing to use it.
- Miele specifies that flow pressure below 7.25 psi (0.5 bar) requires attention from the facility manager or a plumber.
- If the fault continues, arrange Miele service.
Can I keep using it?Follow the Miele checks that match the condition described by the appliance; not every step applies to every model or cause.
Repair usually required?Use only the manufacturer-backed checks on this page. If Miele directs the issue to service or the listed checks do not resolve it, arrange professional service.
If the error keeps returning
Use the linked official Miele support article for the exact source guidance and model-specific details.
Official source
Troubleshooting information verified against manufacturer support documentation.
View manufacturer support page →Safety note:ApplianceSignal provides general troubleshooting information. Always follow the appliance manufacturer's safety instructions and disconnect power when required.