Miele Dishwasher Error Codes

The dishwasher is reporting an electronic or technical condition.

The dishwasher is reminding you to inspect or clean the filter combination.

The dishwasher is reporting a water drainage fault, and water may remain in the wash cabinet.

Miele lists F1 as a valid dishwasher diagnostic fault. The exact component or cause can vary by model.

The dishwasher detected a drainage fault.

The dishwasher water inlet is blocked or restricted.

The dishwasher water inlet is blocked or restricted.

The circulation pump may be blocked or stuck, especially after the dishwasher has been unused for weeks or months; Miele also lists a possible pump-pressure/heating-level-switch fault.

The dishwasher water inlet is blocked or restricted.

The dishwasher is reporting a lack of rinse aid.

The dishwasher is reporting insufficient dishwasher salt.

Miele identifies this code as a technical fault that requires service.

The dishwasher water inlet is blocked or restricted, or the available flow pressure is too low.

The dishwasher filter-cleaning reminder has reached its programmed interval.

Miele identifies this code as a technical fault that requires service.

Water intake valve faulty.

The flow meter (impeller counter) is faulty.

Miele lists F2 as a valid dishwasher diagnostic fault. The exact component or cause can vary by model.

Heating relay contact fault.

Desired temperature fault.

Boiling protection.

Door lock does not open.

Door lock switch faulty.

Miele identifies this code as a technical fault that requires service.

Miele identifies this code as a technical fault that requires service.

Electrical frequency registration fault.

Miele identifies this code as a technical fault that requires service.

Pump pressure level switch fault.

The dishwasher detected excessive foam from too much detergent or rinse aid, and the wash program was interrupted.

Speed sensor fault.

Miele identifies this code as a technical fault that requires service.

Miele identifies this code as a technical fault that requires service.

The AutoDos dispensing system is blocked and the dishwasher has canceled the wash program.

The dishwasher detected an AutoDos installation or operating fault.

The lower spray arm is blocked or its jets are clogged, preventing the AutoDos detergent outlet from being flushed correctly.

Water path control unit fault.

Circulation pump fault.

Circulation pump fault.

The dishwasher circulation pump may be dry, stuck, or jammed after a long period of non-use or first commissioning.

The Miele water-protection system has reacted; the program is canceled and the drain pump runs.

The dishwasher circulation pump is blocked or stuck, often after long periods between uses or during first commissioning.

Circulation pump fault.

Water intake fault.

Miele identifies this code as a technical fault that requires service.

The salt-container flap in the dishwasher door is not closed.

Miele identifies this code as a technical fault that requires service.

Turbidity sensor fault.

Load recognition inactive.

The dishwasher detected a water-supply or drainage fault; water may remain in the wash cabinet.

The rinse-aid or salt indicator is illuminated; this can be normal after adding salt or when using combination detergent tablets.

The Salt indicator is on; it may remain lit for a while after salt is added, and combination tablets can also leave the indicator illuminated.

The Spray arm indicator is flashing because the middle spray arm is blocked or its jets are clogged.

The dishwasher program-sequence indicators are flashing because of a technical condition.

The dishwasher is not receiving the expected water supply.