ERROR CODE EXPLAINED
Miele Washer
Miele Washer F210 Error Code
What it means
The washer suds-circulation system is restricted by lint at the door-seal nozzle or a blocked drain filter/pump.
Try this first
- Carefully remove lint from the nozzle at the top of the door sealing ring with your finger.
- If the drain filter is blocked, use caution because hot wash water can scald and a large quantity of water may remain in the drum.
- Place a suitable container below the drain-pump access panel and loosen the drain filter slowly to control the flow.
- Switch the washer off, open the drain-pump access panel, drain the remaining water, remove and thoroughly clean the drain filters, and verify that the pump impellers rotate freely.
- Remove foreign objects such as buttons or coins, reinstall each drain filter on the correct side, screw the filters tight, and close the access panel.
- The washer can still be used with reduced functionality, but if F210 persists arrange Miele service.
Can I keep using it?Follow the Miele checks that match the condition described by the appliance; not every step applies to every model or cause.
Repair usually required?Use only the manufacturer-backed checks on this page. If Miele directs the issue to service or the listed checks do not resolve it, arrange professional service.
If the error keeps returning
Use the linked official Miele support article for the exact source guidance and model-specific details.
Official source
Troubleshooting information verified against manufacturer support documentation.
View manufacturer support page →Safety note:ApplianceSignal provides general troubleshooting information. Always follow the appliance manufacturer's safety instructions and disconnect power when required.